02/06/04

Engine delivered to D.F. machining, Palmdale CA

 

002.jpg (32834 bytes) 003.jpg (33310 bytes) 004.jpg (29844 bytes) 005.jpg (39707 bytes)
006a.jpg (41076 bytes) 007.jpg (38280 bytes) 008.jpg (39383 bytes)

2/11/04

Jack and I felt the correct way to install the engine would to be to push back the fire wall approx. 3" to allow us to drop the engine between the frame rails so that the engine and transmission would be in line with the drive shaft.

001a.jpg (42714 bytes) 002.jpg (47606 bytes)

02/12/04

001.jpg (44166 bytes)

002.jpg (43795 bytes) Iron Mock Up Block
003.jpg (33100 bytes) A hole that the installer had cut into 

The frame to allow room for the fuel pump 

(wrong ..we'll have to fix that)

You will see photos of the fix. In the following pages.

02/17/04

001.jpg (48003 bytes) Preparing patch for hole. 002.jpg (41208 bytes)

 
004.jpg (35176 bytes) We found a fender that was better than the

one we currently had on the car even though it need repair.

 

 

 005.jpg (42042 bytes)

Monster Garage this ain't